Craftsman CompuCarve 133.217540 Instrucciones de operaciones descargar pdf (Pagina 83)

Chapter 9: Bits & Bit Selection

Routing

Routing is applying a bit to a path at a set depth. This function can be done on any drawing element or outline.

To create a rout, select the desired geometry then press the Select Bit button from the Tools pull down menu or

the Tools toolbar. A dialog will open showing all of the bits available.

Figure 9�1� Select Bit Dialog

Select the desired bit, enter the desired depth and press ‘OK’ to apply the bit. The default depth varies by bit.

Once a rout has been applied the depth may be changed in the Depth Entry Box on the Input Toolbar. To change

the bit press the Select Bit button and select the bit. The “No Bit” button may be pressed to deselect any bit

which will tyrn the input and depth boxes red indicating invalid values. Clicking the ‘No Bit’ button will revert

the selected gure back to a dotted path.

Possible Machine Damage

Warning! Never try to use a Rout to cut a piece out of a board. The piece can get

caught by the spinning bit and cause damage to the CarveWright/CompuCarve

machine. Use the Cut Path option explained later in this chapter or jig if rout cut

through can not be avoided.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 218 219

Sin comentarios

Craftsman CompuCarve 133.217540 Instrucciones de operaciones Pagina 83