Craftsman CompuCarve 133.217540 Instrucciones de operaciones descargar pdf (Pagina 143)

142

Chapter 16: Uploading

Upload Project

The Upload Project dialog (Figure 15.6) show all the le settings that can be made before the project is

uploaded to the memory card. Any projects that are currently on the card can also be seen on this screen along

with the space available and the le size for the current project. This is very important if there is not enough

room on the memory card to upload it. If the previous situation is the case, then cancel the upload process

and go to ‘Flash Manager’ under the ‘File’ Menu (explained in the next chapter: Memory Card Management.)

Otherwise continue with the upload process with the information for the Upload Project dialog.

Figure 16�6� Upload to Flash Dialog

File Name

The le name is the name that will be stored on the memory card for the current project and will display on the

CarveWright/CompuCarve Woodworking Machine display screen when selecting the which project to carve.

The default lename is lename that has been saved to the computer. If the le has not been saved then the

default name that will display is “Unnamed”.

A project can not be recovered from the memory card so it is recommended that the project is saved to the

computer before closing the CarveWright Designer Software.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 218 219

Sin comentarios

Craftsman CompuCarve 133.217540 Instrucciones de operaciones Pagina 143