Craftsman CompuCarve 133.217540 Instrucciones de operaciones descargar pdf (Pagina 144)

143

CarveWright Designer Software Manual

Quality Settings

The Quality Setting selected for the project will change the detail of the carve as well as the amount it will take

to carve. The following options are available from the Quality settings drop down box:

Draft: Requires the minimum time to carve but spacing of the passes

will be noticeable. This setting is useful for large carvings that will

not be viewed up close.

Normal: This is the standard balance between carving time and

output quality. Good quality carvings though some passes may still

be visible with this setting.

Best: Requires a longer time to carve than the Normal setting. High

quality carving with no passes visible

Optimal: Maximum carving time with the most accurate carving

results.

Run Time

Based on the Quality setting selected, Estimated Project Run Time will change accordingly. This is an estimate

and not an exact time as there are other factors that can increase this time such. The format for reading the

estimated time is hours, then minutes, then seconds. This would mean that 07:13 is seven minutes and thirteen

seconds, not seven hours and thirteen minutes.

Designer Version

The designer version will display what the current software version is installed that the project was designed

in. This is very important when the software is updated as changes to the operation of the CarveWright/

CompuCarve Woodworking Machine can conict with the instructions of the Project that is to be carved. It is

best to re-upload the projects on the memory card whenever an update has been installed to the computer.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 218 219

Sin comentarios

Craftsman CompuCarve 133.217540 Instrucciones de operaciones Pagina 144