Craftsman CompuCarve 133.217540 Instrucciones de operaciones descargar pdf (Pagina 55)

Chapter 6: Drawing

Drawing Tools

Drawing is accomplished by the use of the following tools:

Line Segment Tool: Select this tool, then left-click on the board to begin a line segment. Left-click

again to end it. You may also click and drag to create a segment.

Connected Lines Tool: Select this tool, then left-click on the board to begin a line segment. Each

successive left click ends the previous segment and begins a new one. To end the segments, you may

either double-click to place a nal segment, click on the last vertex placed, press the ESC key, or

click on the rst vertex to create a closed loop.

Spline Tool: Select this tool, then left-click on the board to begin a curved segment. Each successive

left click ends the previous segment and begins a new one. You need to create two or more

connected segments to see the curve effect. To end the segments, you may either double-click to

place a nal segment, click on the last vertex placed, press the ESC key, or click on the rst vertex to

create a closed loop.

Square Tool: Select this tool, then left-click on the board to start a square, and then left-click again

to end it. You may also click and drag to create a square. Squares will maintain their square aspect

when manipulated.

Rectangle Tool: Select this tool, then left-click on the board to start a rectangle, and then left-click

again to end it. You may also click and drag to create a rectangle.

Circle Tool: Select this tool, then left-click on the board to place the center of the circle, then left-

click again to end it. You may also click and drag to create a circle. Circles will maintain their

circular aspect when manipulated.

Oval Tool: Select this tool, then left-click on the board to place the center of the oval, then left-click

again to end it. You may also click and drag to create an oval.

Arc Tool: Select this tool, then left-click on the board to place one end of the arc, then left-click to

place the other end. You may also click and drag to create an arc. Either way you need to click and

drag the Green Control Point to change the radius of the arch.

Spiral Tool: Select this tool, then left-click to place a spiral. It may then be manipulated by dragging

the yellow border to widen the loops or by dragging its vertices to set the starting and ending loops.

Sine Tool: Select this tool, then left-click to place a sine wave. It may then be manipulated by

dragging the yellow border to widen or lengthen the loops. You may also click and drag its vertices

to set the starting and ending loops

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 218 219

Sin comentarios

Craftsman CompuCarve 133.217540 Instrucciones de operaciones Pagina 55