Craftsman CompuCarve 133.217540 Manual del operador descargar pdf (Pagina 9)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

Glossary

Bevel Cut - A cut made across a workpiece that results in an angle other

than 90˚ to the table surface.

Cross Cut - A cutting operation across the grain or width of the

workpiece.

Head Screw - The threaded shaft on each side of the machine by which

the head is raised and lowered when activated by the head crank.

Joint or Jointing - A trim cut parallel to the grain of the wood on the

edges of a board to create 90-degree angle with the top and bottom

surface. A joint will create a smooth and, most important, straight edge.

Often used in preparation for a glue joint to attach the board to another

piece of wood.

LCD - Liquid Crystal Display – The two-line text display found above the

keypad.

Miter Cut - A vertical cut made at any angle other than 0˚ across the

workpiece.

Molding - A shaping cut that gives a varied profile to the workpiece.

Pitch - A sticky, sap-based substance found in some woods.

Raster Carving - A carving produced by taking many small passes with

the carving bit, building the image one line at a time.

Rip Cut - A cut made parallel to the grain or length of the workpiece.

Rout - To hollow, scoop or carve out.

Snipe - An unwanted depression formed near the end of a workpiece

caused by the uneven transition of the workpiece from one support

surface to another. Minimize snipe by ensuring that the auxiliary outfeed

supports are properly adjusted. The free end of the workpiece should also

be well supported so that its weight does not place lifting pressure at the

end of the workpiece being carved.

Squaring Cut - A smoothing trim cut across the grain of the wood on the

end of a board to create 90-degree angles with the top, bottom, and side

edges.

Vector Cut - A cutting operation that is composed of a group of strokes

from one point to another. These can be lines, circles, splines or any

other number of geometric elements.

Workpiece - The item on which the cutting operation is being performed.

The surfaces of a workpiece are commonly referred to as faces, ends, and

edges.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 45 46

Sin comentarios

Craftsman CompuCarve 133.217540 Manual del operador Pagina 9