Craftsman CompuCarve 133.217540 Manual del operador descargar pdf (Pagina 34)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

Lift

Slide

Bit Assembly Removal

To remove a bit quickly, a thumb should be placed on the Z-Truck Grip

Ridge (see Figure 28 below) and the Chuck Release Flange should be

pulled up while pulling lightly on the bit with the opposite, gloved hand.

WARNING: Use caution to avoid being cut by the sharp

cutting edges of the router bit. Use caution if the bit has

recently been in use; it may be HOT and a glove will be

required to handle it.

Alternately, the supplied bit

removal tool can be used to

extract the router bit as shown in

Figures 29 and 30. Slide the

removal tool under the release

flange and into the adapter slot

and then lift the handle in a

gentle prying motion. The

removal tool straddles the bit

adapter to hold it and keep it

from falling as the bit is released.

The bit and its collet assembly

will drop out onto the removal

tool as it lifts the release flange.

After removing a bit using the

removal tool, the quick release

chuck may be left un-cocked.

To cock it, push the flange up on

the chuck to prepare for insertion

of another bit.

FIGURE 28: QUICK RELEASE CHUCK FEATURES

IGURE 29: BIT REMOVAL TOOL INSERTION

IGURE 30: BIT RELEASE WITH TOOL

Chuck

Release

Flange

Z-Truck Grip

Ridge

Bit Removal Tool

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

Sin comentarios

Craftsman CompuCarve 133.217540 Manual del operador Pagina 34