Craftsman CompuCarve 133.217540 Manual del operador descargar pdf (Pagina 8)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

To reduce exposure to these chemicals:

• Work in a well ventilated area

• Work with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles

• Keep the machine and work area clean

IMPORTANT NOTE: Servicing requires much care and specialized

knowledge of the system and should be performed only by a qualified service technician.

For service, return the machine to the nearest repair center in the original packaging.

Electrical Connections

POWER SUPPLY

The CompuCarve woodworking machine is controlled by precision electronics. It should

be connected only to a power supply that is 120 volts nominal, 60 Hz, AC (normal

household outlet). It should not be connected to a 240-volt power supply. This tool will

not operate on direct current (DC). If the machine does not operate when plugged into

an outlet, check to see that the fuse or circuit breaker for the outlet is not open and that

the outlet has power available. The plug has polarized terminals so make sure that it is

inserted properly into the outlet.

EXTENSION CORDS

When using a power tool at an extended distance from the power source, use an

extension cord heavy enough to carry the current that the tool will draw. An undersized

extension cord will cause a drop in line voltage, resulting in a loss of power and causing

potential damage to the machine. Use the chart provided below to determine the

minimum wire size required in an extension cord. Only jacketed cords listed by

Underwriter's Laboratories (UL) should be used.

Length of Extension Cord vs. Minimum Wire Size (American Wire Gage - AWG)

Up to 10 feet - 18 AWG

10 to 50 feet - 14 AWG

Over 50 feet – not recommended

When working with the tool outdoors, use an extension cord that is designed for outside

use (This is indicated by the letters WA on the power cord's outer jacket). Before using

an extension cord, inspect it for loose or exposed wires and cut or worn insulation.

Storing the Machine

It is important that the CompuCarve be stored indoors in a low humidity environment.

Never expose the machine to temperatures of over 110 degrees Fahrenheit for any

extended period of time. The machine should not be used in an environment with a

temperature of less than 40 degrees Fahrenheit. Make sure that all exposed metal

surfaces on the quick release chuck and bit adapters are well oiled for operation and

storage.

Be sure to keep the box and packing foam in case the machine

needs to be returned for service.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Sin comentarios

Craftsman CompuCarve 133.217540 Manual del operador Pagina 8