Craftsman CompuCarve 133.217540 Manual del operador descargar pdf (Pagina 27)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

If possible, measure the workpiece to carve before starting the

project layout in the software. This will help guide the design and

prevent unintended scaling issues if the project design is different

then the available workpiece. Measuring it with the machine will be

the most accurate way.

If the inserted workpiece is larger than the project design then the

available options are: Keep Original Size, Scale the project to fit the

workpiece, or Load New Board. If Keep Original Size or Scale is selected

then options Center On Board, Jog To Position, or Place On Corner are

displayed in order to locate the project on the workpiece.

Once all of the required data has been entered, the machine will prompt to

insert the required bit. It will first ask to confirm the bit. Pressing ENTER

will then move the cutting truck to the center of travel for easier access to

the quick change. For projects that require more than one bit, the

machine will prompt for each bit at this point and will store the calibration

settings. The machine will locate the bit tip with its touch plate and will

then locate the top surface of the board by touching the bit tip to the

surface of the workpiece.

If the workpiece chosen has existing carved features or defects that would

prevent the bit from touching the top surface, it is possible to choose

where the bit will touch when finding the board surface. To do this watch

as the machine begins the operation to find the bit tip position. The

message Finding Surface will be displayed on the LCD. Press the STOP

key when this message appears. When prompted choose the Jog To

Touch option. Use the arrow keys to move the bit tip to a suitable flat

spot on the board and press ENTER to record position. The machine will

remember this location and use it to locate the tips of all the bits used in

the project. It is also possible to make "Jog To Touch" the default method

by choosing this in the Configurations Menu. This option remains set only

until the machine is powered off.

The machine will then proceed to carve the project. A real time carving

completion estimator will be displayed on the LCD and provides an

estimate of how much of the current carving is completed. This

completion estimator gives a completion estimate for the element that is

carving at the time and does provide and estimate for the entire project. A

time estimate for the entire project can be obtained in the design software

when the project is uploaded to the memory card.

When the carving is completed, lift the top safety cover, release the head

lockdown lever, and crank the head up to free the workpiece. The

workpiece can then be removed and examined.

After removal from the machine, it is advisable to brush any

“whiskers” from the carving with a small brass utility brush, and to

blow it free of dust with compressed air.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Comentarios a estos manuales

Sin comentarios

Craftsman CompuCarve 133.217540 Manual del operador Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Craftsman CompuCarve 133.217540