Craftsman 28180 - Fixed-Base Router/Table Combo Manual descargar pdf (Pagina 53)

Trouble

I -The router does not

work

• The surface of the

work piece is not

smooth after cut-

ting

Probable Cause

-Plug is not plugged into

the power source.

*Plug is not plugged into

the Router socket.

*Switch is in "OFF" posi-

tion.

*The carbon brushes

have worn out com-

pletely.

*The bit is dull.

-Routing at an inappropri-

ate bit speed.

*Bit can not be *Bit size is inappropriate

installed for the collet/nut

Solution

-Plug the detachable cord

into the power source.

• Plug the detachable cord

into the Router.

• Pull the switch to "ON"

position.

• Open the brush cap, and

replace the old brushes with

suitable new brushes.

• Change to a sharp bit.

-Refer to "Variable Speed

Selection Chart" label on

the Router Motor cap, and

select an appropriate bit

speed.

• Use only 1/2 in. or 1/4 in.

diameter bits.

28084 Manual Revised 07-0712 Page 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

Sin comentarios

Craftsman 28180 - Fixed-Base Router/Table Combo Manual Pagina 53