Craftsman 28180 - Fixed-Base Router/Table Combo Manual descargar pdf (Pagina 36)

The speed charts above indicate the relationship between the speed setting and

the cutting application. Exact settings are determined through operator experience

and preference, and by recommendations by the cutting-bit manufacturer.

ELECTRONIC FEEDBACK CIRCUITRY

Electronic feedback circuitry monitors and adjusts power in order to maintain the

desired RPM for consistent performance and control, providing constant speed

under load for a quality finish in all materials

PLACING THE ROUTER ONTO THE WORKPIECE AND STARTING THE CUT

,_ WARNING: Before operating the router, follow all safety instructions in this

manual. Failure to do so could result in serious personal injury.

NOTE: Making test cuts is essential with most routing applications. A test cut

will give a feel for the set-up, the router's speed, the depth of cut, and how the

cutting bit reacts to the workpiece.

Much of routing is a trial-and-error process of making various adjustments, followed

by test cuts. To avoid ruining good material, make test cuts on scrap materials.

28084 Manual Revised 07-0712 Page 36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sin comentarios

Craftsman 28180 - Fixed-Base Router/Table Combo Manual Pagina 36