Craftsman 113.298720 Instrucciones de operaciones descargar pdf (Pagina 41)

IfbladeisNOT45° STOPCOLLARandSCALEmust

beADJUSTED.

1.RemoveElevationHandwheel.

2. Usingasmallsizescrewdriver,reachthrucurved

slot infront trim panelandloosenBOTHset-

screwsin45° STOP COLLAR.

NOTE: If you can't reach the setscrews, turn the

TILT HANDWHEEL slightly.

3. ROTATE the STOP COLLAR moving it IN or

OUT and TILT blade RIGHT or LEFT . . .

checking with your square until blade is 45° to

table.

4. TIGHTEN the setscrews.

NOTE: If you can't reach the setscrews, turn

TILT HANDWHEEL slightly.

5. Loosen two screws on scale and adjust scale

until POINTER points to 45° mark.

6. Install Elevation Handwheel.

TiLT MECHANISM

The handwheel should turn freely without binding.

The turning action can be adjusted by tightening or

loosening the screws in the bearing retainer.

NOTE: Tilt Handwheel must be removed to adjust.

When adjusting the screws _nthe bearing retainer,

hold the nut inside using a 3/8 in. wrench.

TILT HANDWHEEL

ADJUST THESE

TWO SCREWS

MAINTENANCE

WARNING: FOR YOUR OWN SAFETY, TURN

SWITCH "OFF" AND REMOVE PLUG FROM POWER

SOURCE OUTLET BEFORE MAINTAINING OR

LUBRICATING YOUR SAW,

Do not allow sawdust to accumulate inside the saw.

Frequently blow out any dust that may accumulate

inside the saw cabinet and the motor.

Frequently clean your cutting tools with Craftsman

Gum and Pitch Remover.

A coat of automobile-type wax applied to the table

will help to keep the surface clean and allow work-

pieces to slide more freely.

If the power cord is worn or cut, or damaged in any

way, have it replaced immediately.

Make sure the teeth of the ANTIKICKBACK pawls

are always sharp. To sharpen:

1 Remove blade guard.

2. Rotate paw l toward rear of spreader so that tee1

are above top of spreader.

3. Hold spreade rwith left hand and place pawl ov

corner of workbench.

4. Using a smatl round file (Smooth Cut) sharp_

the teeth.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Comentarios a estos manuales

Sin comentarios

Craftsman 113.298720 Instrucciones de operaciones Pagina 41

Comentarios a estos manuales