Craftsman evolv 320.17263 Manual del operador descargar pdf (Pagina 3)

A_, WARNING: Be sure to read and understand all instructions in this manual

before using the reciprocating saw. Failure to follow all instructions may result in

hazardous radiation exposure, electric shock, fire, and/or serious personal injury.

_, WARNING: Do not attempt to operate this tool until you have thoroughly

read all instructions, safety rules, and warnings. Failure to comply with them can

result in fire, electric shock, or serious personal injury. Save the manual and refer

to it frequently.

GENERALSAETYPRECAUTIONS

WORK AREA SAFETY

Keep work area clean and well lit. Cluttered or dark areas invite accidents.

Do not operate power tools in explosive atmospheres, such as in the

presence of flammable liquids, gases or dust. Power tools create sparks

which may ignite the dust or fumes.

Keep children and bystanders away while operating a power tool.

Distractions cause you to lose control.

ELECTRICAL SAFETY

Double insulated tools are equipped with a polarized plug (one blade

is wider than the other.) This plug will fit in a

polarized outlet only one way. If the plug does not

fit fully in the outlet, reverse the plug. If it still does

not fit, contact a qualified electrician to install a

polarized outlet. Do not change the plug in any

way. Double insulation eliminates the need for the

three wire grounded power cord and grounded power

supply system.

Avoid body contact with grounded surfaces such

as pipes, radiators, ranges and refrigerators. There

is an increased risk of electric shock if your body is

grounded.

Don't expose power tools to rain or wet conditions. Water entering a

power tool will increase the risk of electric shock.

Do not abuse the cord. Never use the cord to carry the tools or pull

the plug from an outlet. Keep cord away from heat, oil, sharp edges or

moving parts. Replace damaged cords immediately. Damaged cords

increase the risk of electric shock.

• When operating a power tool outside, use an outdoor extension cord

marked "W-A" or "W". These cords are rated for outdoor use and reduce

the risk of electric shock. The following table shows the correct size to

use, depending on cord length and nameplate amperage rating of the tool.

17434 Manual Revised 09-0727 Page 4

When in doubt, use the next heavier gauge. Always use UL and CSA listed

extension cords.

Recommended sizes of extension cords

Ampere Rating

More Than

Not More Than

Volts

120v

Total Length of Cord in feet

25ft 50ft 100ft 150ft

AWG

18 16

16 16

14 12

16 14

14 12

Not Recommended

PERSONAL SAFETY

Stay alert, watch what you are doing and use common sense when

operating a power tool. Do not use tool while tired or under the

influence of drugs, alcohol, or medication. A moment of inattentionwhile

operating power tools may result in serious personal injury.

Dress properly. Do not wear loose clothing or jewelry. Contain long hair.

Keep your hair, clothing, and gloves away from moving parts. Loose

clothes, jewelry, or long hair can be caught in moving parts.

Avoid accidental starting. Be sure switch is off before plugging in.

Carrying tools with your finger on the switch or plugging in tools that have

the switch on invites accidents.

Remove adjusting keys or wrenches before turning the tool on. A wrench

or a key that is left attached to a rotating part of the tool may result in

personal injury.

Do not overreach. Keep proper footing and balance at all times. Proper

footing and balance enables better control of the tool in unexpected

situations.

• Use safety equipment. Always wear eye protection. Dust mask, non-skid

safety shoes, hard hat, or hearing protection must be used for appropriate

conditions.

Before connecting the tool to a power source (receptacle, outlet, etc.),

be sure voltage supplied is the same as that specified on the nameplate

of the tool. A power source with voltage greater than that specified for the

tool can result in serious injury to the user - as well as damage to the tool.

TOOL USE AND CARE

• Use clamps or other practical way to secure and support the workpiece

to a stable platform. Holding the work by hand or against your body is

17434 Manual Revised 09-0727 Page 5

1 2 3 4 5 6 7 8 ... 12 13

Comentarios a estos manuales

Sin comentarios

Craftsman evolv 320.17263 Manual del operador Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Craftsman evolv 320.17263