Craftsman 21807 - 10 in. Table Saw Manual del operador descargar pdf (Pagina 3)

2 3

PRODUCT SPECIFICATIONS

MOTOR

Type............................................................................. Universal

Amperes....................................................................... 15 Amp

Voltage........................................................................ 120V AC

Hz................................................................................ 60Hz

RPM (no load) ............................................................ 5000 RPM (No load)

Overload Protection.................................................... Yes

BLADE SIZE

Diameter...................................................................... 10 in.

Arbor size.................................................................... 5/8 in.

SAW

Rip fence...................................................................... Yes

Miter gauge.................................................................. Yes

Rip Capacity ................................................................ 24 in. Right & Left

Maximum Cut Depth @ 90º ......................................... 3 in.

Maximum Cut Depth @ 45º ......................................... 2-1/2 in.

Maximum Diameter Dado ............................................ 6 in. (Stackable only)

Maximum Dado Cut Width ........................................... 1/2 in.

WARNING

To avoid electrical hazards, ﬁre hazards or damage to the tool, use proper

circuit protection.

This tool is wired at the factory for 110-120 Volt operation. It must be

connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker.

To avoid shock or ﬁre, replace power cord immediately if it is worn, cut or

damaged in any way.

Before using your tool, it is critical that you read and understand these

safety rules. Failure to follow these rules could result in serious injury to

you or damage to the tool.

1 2 3 4 5 6 7 8 ... 55 56

Sin comentarios

Craftsman 21807 - 10 in. Table Saw Manual del operador Pagina 3