Craftsman 247.774500 Manual del operador descargar pdf (Pagina 5)

IMPORTANT:This unit is shipped without gasoline or

oil in the engine. Be certain to service engine with

gasoline and oil as instructed in the separate engine

manual before operating your machine.

NOTE: Reference to right or left hand side of the log

spfitter is observed from the operating position.

RemovingUnitFromCarton

• Pry the top, sides, and ends off crate.

• Set panels aside to avoid tire punctures or

personal injury.

• Remove and discard plastic bag that covers unit.

• Remove any loose parts if included with unit (i.e.,

operator's manual, etc.)

• Cut and remove straps which secure parts to

bottom of crate. Unbolt any remaining parts which

may be bolted to the bottom of the crate.

WARNING: Use extreme caution unpack-

ing this machine. Some components are

very heavy and will require additional

people or mechanical handling

equipment.

LoosePartsinCarton

• Tongue Assembly

WARNING: Disconnect the spark plug

wire and ground against the engine to

prevent unintended starting.

AssemblingTheTongue

AttachingTheJack Stand(SeeFigure1)

• The jack stand is shipped inthe transport

position.

• Remove the spring clip and clevis pin and pivot

the jack stand to the operating position.

• Secure the jack stand in positionwith the clevis

pin and spring clip.

Clevis

Spring_ Pin

(Operating .....Position)JackStand _ _J

Figure 1

AttachingThe Tongue(SeeFigure2)

• With the log splitter still standing upright, remove

two hex bolts, lock washers, and hex nuts from

the tongue assembly.

• Align the holes in the tongue with the holes inthe

tank and secure with hardware just removed.

_ Vertical Lock

r / Alhig;eWHitohes

((1"_'_'_ I /_ Pre?;ure

Figure 2

ConnectingtheCylinderto Beam

• The log splitter is shipped with the beam inthe

vertical position. Pull out the vertical lock rod,

rotate it back, and pivot the beam to the

horizontal position untilit locks. See Figure 2 &

Figure 3.

• Disconnect the dislodgerfrom the beam weld

bracket by removing the six hex screws and fiat

washers. See Figure 3.

Vertical Lock

Dislodger

Remove

Log

Horizontal

Lock

Figure 3

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comentarios a estos manuales

Sin comentarios

Craftsman 247.774500 Manual del operador Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Cortadoras De Troncos Craftsman 247.774500