Craftsman 113.198611 Operators Manual del operador descargar pdf (Pagina 29)

1 E

Fig. 78 - Parts for Mounting Table

1. Place a tee nut over each of the leveling

holes and hammer them into place.

(Figure 79)

U-Clips

/U-Clip On

_Center Channe

U-Clips

Fig. 80

3. Slide one U-clip over the hole in the left

side of the center channel as shown.

(Figure 80)

4. Put a washer on each of the mounting

screws. (Figure 81)

Fig. 81 - Mounting Screw and Washer

Mounting

Holes

Leveling Holes

Mounting Holes

Leveling Hole

Front Table - Upside Down

Fig. 79 - Leveling and Mounting Holes

2. Slide four U-clips over the holes in the saw

as shown. (Figure 80)

5. Stand the front table on one edge.

6. Put a mounting screw through each of the

mounting holes. Then put a rubber grommet

on the bottom of each mounting screw.

(Figure 82)

_,.._,. Table Rail _/

Rubber _-% Table Rail -----"lll_

GrommetIt,I _ /

_'_ __nti £g Holes/

t _Moon,ing .o,e_J _

I Holes o \

'_Front Edge

Fiq. 82

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 119 120

Sin comentarios

Craftsman 113.198611 Operators Manual del operador Pagina 29